:: Palit ARGB-SYNC ::

Palit ARGB SYNC - Installation Guide

This ARGB strip supports 5V only. Please follow below steps for installation.If any help needed, please contact our technical support team: support@palit.com

STEP-01

Connect the smaller end Ⓐ to GPU’s connector. The connector is non-directional, so you don’t need to worry about damaging the card with wrong connection.

STEP-02

Connect Ⓑ (female) connector to the motherboard or other ARGB controller.

NOTE: The ARGB strip supports 5V only (from the motherboard header or ARGB controller.) Incorrect connection may lead to damage of the strip.

STEP-03

If you have other ARGB-supported devices, you can connect Ⓒ (male) connector to the ARGB strip.

NOTE: If you are not using the Ⓒ (male) connector, please do NOT remove the protection cap in order to prevent the strip from damage.

STEP-04

Please download the ThunderMaster and select “ARGB SYNC” under the “Lighting” tab. The software which controls the ARGB of PC devices will then be able to sync the lighting of PALIT graphics card.